RM3090E _56 Audio / Visual / Telematics _008432 PARK ASSIST / MONITORING _0105629 REAR VIEW MONITOR SYSTEM(for Radio and Display Type) L

PARK ASSIST / MONITORING  REAR VIEW MONITOR SYSTEM(for Radio and Display Type)  PRECAUTION  


IGNITION SWITCH EXPRESSION


HINT:

The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

Expression Ignition Switch (Position) Engine Switch (Condition)
Ignition Switch off LOCK Off (Lock)
Ignition Switch ACC ACC On (ACC)
Ignition Switch ON ON On (IG)
Engine Start START On (Start)



NOTES FOR REAR TELEVISION CAMERA ASSEMBLY


a.

Notes for the rear television camera assembly

i.

The rear view monitor system may not function properly if subjected to a severe blow by any hard object.


ii.

Do not scrub the camera lens. Scrubbing may scratch the camera lens and affect the image.


iii.

The cover part of the camera is made of resin. Prevent organic solvents, waxes, bond removing solvents or glass coating from adhering to the cover. If such material adheres to the cover, clean it off immediately and wash it with water.


iv.

Exposing the camera to a sudden temperature change may affect proper functioning of the camera.


v.

A clear image may not appear if the camera is dirty with snow, mud, etc. In that case, wash it with water and wipe off the lens. Use a detergent to remove dirt if necessary.


vi.

When washing the vehicle with a high-pressure washer, do not spray water on the rear television camera assembly or surrounding area. High-pressure water can damage the camera.



b.

Images may be unclear even in normal conditions if:

i.

Electrical devices are used in the cabin (noise may occur in the image).


ii.

Accessories that generate radio waves have been installed (noise may occur in the image).


iii.

The outer mirror switch assembly is operated (noise may occur in the image).


iv.

The multi-display is cold (the image immediately after turning the ignition switch to ON may be blurred or darker than normal).


v.

The camera lens is dirty with snow, mud, etc.


vi.

A strong beam of light, such as a sunbeam or headlight, hits the camera.


vii.

It is too dark around the camera (at night etc.).


viii.

The ambient temperature around the camera is either too high or too low.


ix.

The vehicle is tilted at a steep angle.


x.

The rear television camera assembly lens is scratched.


xi.

The rear television camera assembly lens has drops of water on it or the humidity is high.


xii.

When the camera is used under fluorescent lights, sodium lights, or mercury lights etc., the lights and the illuminated area may appear to flicker.